GE AGM10 Owner's Manual And Installation Instructions page 7

GEAppliances.com
Additional controls and important information.
Energy Saver
(on some models)
The energy saver switch controls the tan.
O]_-The tim and compressor cycle on and off
togethei: This results in wider \m_iafions
of rooln
temperature and humidi_'. Noi_nallv used when
the roonl is unoccupied.
OFF The tim runs all the time, while the
compressor cycles on and off.
This switch must be set at OFFin order to use the
tim settings (t/i1 the inode control).
Vent Control
The vent control is located above the
control knobs.
X4]_en set at CLOSE, (rely the air inside the I"OO1//
will be ciIvulated and c(mdifioned. \4Iron set at
OPEN, s()me inside air is exhausted outside.
Toopenthe vent,pull the levertoward you.
Tocloseit,pushit h?.
Air Direction--Side-to-Side
On some models, the side-to-side air direction is
a(!justed by moving the lever to the left or right.
CIRCULAIRE(on some modem
For fixed side-to-side air direction, set the
Circulaire switch to 0/I/until the desired air
direction is obtained, then move it to
OFF.
For continuous side-to-side air drculation (cool
settings only), set the Circulaire switch to ON.
CIRCULAIRE
OFF ON
Air Direction--Up and Down
Fingertip pressure on the horizontal lou\'ei_ a(!iusts
the air direction up or down.
(on some models)
7