Download Print this page

Troubleshooting Tips - GE WHRE5550H2WW Owner's Manual

Advertisement

Before you call for service...
Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit ge.com. You may not need to call for service.
WATER
Possible
Causes
What
To Do
Too many suds
Too much detergent
• Measure your detergent carefully. Use less soap if you have
soft water, a smaller load or a lightly soiled load.
Type of detergent
• Switch to HE detergent.
Soft water
• Try less detergent.
Water leaks
Using too much detergent
• Use less detergent. Use less soap if you have soft water,
in washer
a smaller load or a lightly soiled load.
Fill hoses or drain hose is
• Make sure hose connections are tight at faucets and
improperly
connected
rubber washers are installed. Make sure end of drain hose
is correctly inserted in and secured to drain facility.
Household drain may
• Check household plumbing. You may need to call
be clogged
a plumber:
Constant water pressure
• Tighten hoses at the faucets and turn the water off after
to the fill hoses at the
each use.
water source
• Check condition of the fill hoses; they should be replaced
every 5 years,
Water temperature
Cooler water temperatures
• New laundry detergents have been formulated
to work
seems incorrect
provide improved energy
with cooler water temperatures
without affecting wash
efficiency
performance.
Water supply is turned off
• Turn both hot and cold faucets fully on and make sure
or improperly
connected
hoses are connected to correct faucets.
Water valve screens are
• Turn offthe water source and remove the water connection
stopped up
hoses from the upper back of the washer: Use a brush or
toothpick to clean the screens in the machine. Reconnect
the hoses and turn the water back on.
House water heater is
• Make sure house water heater is delivering water at
not set properlg
120°F-140°F (48°C-60°C).
Water pumped
out before
Lid lifted or cycle was put in
• Reset cycle.
cycle is complete
pause
for over 24 hours
Water
won'tdrain
Drain hose is kinked or
• Straighten
drain hose and make sure washer
is not
improperly
connected
sitting on it.
• Top of drain outlet should be less than 6 ft (!.8 m)
above floor:
Washer
pauses
during
The PREWASH Cycle or
• This is normal. The washer
alternates
between
agitate
and
wash cycle
AUTO SOAK Option was
soak during these
cycles to get your clothes cleaner with
chosen
less wear:
Washer
pauses
during
This is normal
• The washer
may pause during the spin cycle to remove
spin cycle
soapy water more efficiently.
10

Hide quick links:

Advertisement

loading