GE WLSE4210 Owner's Manual page 12

Beforeyou call forservice...
Pilling
Snags,holes,tears,rips
or excessivewear
Wrinkling
Possible Causes
Result of normal wear on
poly-cotton blends and
fuzzy fabrics
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers, and sharp objects
left in pockets
Undiluted chlorine bleach
Chemicals like hair bleach
or dye, permanent wave
solution
What ToDo
• While this is not caused by tile washer, you can slow tile
pilling process by washing garments inside out.
• Fasten snaps, hooks, buttons, and zippers.
• Remove loose items like pins, objects in pockets and
shaq) buttons.
• Turn knits (which snag easily) inside out.
• Check bleach package instructions for proper amount.
• Never add undiluted bleach m wash or allow clothes to
come in contact _4th undiluted bleach.
• Rinse items that may hmTe chemicals on them befbre
washing.
Improper sorting
• Avoid mixing hemy items (like work clothes) with light
items (like blouses).
Overloading or
incorrect water level
Incorrect wash and
dry cycles
Repeated washing in
water that is too hot
• Tpy a f_lbric softener.
• Load your washer so clothes have enough room to
move freely.
• Match Cycle selection to the type off_tbric you are
washing (especially fbr easy care loads).
• Wash in warm or cold water.
iii iiiil!! iliii!/iliti!iiii! iiil
ii 5 4 )():()
ii_ / (ii )iiiii i:i!i? _iiiiii
!i iii:! ()!)
! _!i)i _ )!/!/!/!/!/!/!/!
Possible Causes
Washer is uneven
What ToDo
• To level tile front of the washer, adjust tile front leveling
legs by rotating tile indMdual leg in tile proper direction
for up or down. To level back of washer, lifi back of
machine 4" (11 Cln) and set down.
Washer load is • Press PAUSE to stop tile washer, open file lid and
unbalanced redistribute tile load evenly. Close tile lid and press
START.
Shipping rod is still assembled • To remove shipping rod fi'om washer, pull yellow tag and
in unit attached rod fi'Oln tile bottom tight hand side of washer.
Washer is sitting too close • Pull washer a_v_ly fI'OUl t ile wall; about 4" (11
CUl)
to wall (causes knocking is needed.
during cycle)
Labelson theexterior
ofthe washerwill not
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
What ToDo
• Use a hair (hyer set at tile lowest heat setting, directing
the air at the label fbr a short mnount of time. This will
release the adhesive easily, without dmnaging the stu{>me
of tile washer.
72