Danby Millenium DWC450W Owner's Manual page 3

I ' I'll I1' IIII I' I ......................
0 Before Putting .hlto Use ..........................
• Before connecllng the appliance to the
electrical supply, leave it stand Jot about 2
hours, which wilt reduce a possibifilyof
mallunctions in the cooling system due to
transport handling.
- Clean the appliance, and be thorough,
especially in the interior (See Cleaning and
Maintenance)
• In case the Inlet)or accessories are not
correctly placed, rearrange them as described
in chapter "Description of the Appliance"
Instructions for Use
These instruclions for use are intended for the
user° They describe the appllance and
procedures for safe and proper use.. These
instructionswere prepared for vadoue
types/models of refrigerators and certain
tolerances (functions and accessories) may not
be applicable for the model you selected.
SAVE THESE INSTRUCTIONS
refrigerator as soon as ice/Host layers reach 3-
5 mm (1/8" -3/16") thick.
= If the door gaeket is damaged and!or not
sealing properly, energy consumption will be
substantially higher. To restore efficiency,
replace the door gaskeL
• The condenser grill located on the {exterior)
rear waif should always be kept clean, free of
dust and {mpurilies° (sea cleaning the
appffance)
,, Always consider Instructions stated In sections
Posiltonthgand Energy Saving Tips, other,_se
energy consumption is increased.
= Our products use environmerdaiiy fdendly
packaging, which can be either recycled or
disposed of in an environmentally fdendly
manner. To Ihis end, tndiv{duafpackaging
matedafe are clearly ma_ked.
,_These Instrucllonsare printed either on
recycled paper or chlorine free bleached paper.
• The refrigerating system on this app_ance is
filledwtlh refrigerant and eli, If the appliance Is
damaged, handle it with care and dispose of it
in accordance w)th environmental protegee
requirements.
• Try not to open the door too often, especially
when the weather is hot and humid. Once you
open the door, close tl as soon as possible.
This is especially important for all updght
models..
• Every new and then check If the appliance Is
sulfic[enlly venliJated (adequate air eireulat_on
behind the appliance).
,, Set thermostat from higher to lower se_llngs as
soon as possible (ibis will depend on the load
conditions of the appliance and ambient
temperatures etc).
• Accumulation of toe and frost layers (tear wall
evaporator) increase energy consumption, so II
may be necessary to clean (deftest) Ihe
4 Instructions for Uee