Installtherefrigerator - GE TFH22PRXAAA Owner's Manual

Preparing to installtherefrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (o, s ome mo o s)
If the refiigerator has an k emaker, it _dll have to be
( onne( ted to a told water line.
A water supply kit (containing copper tubing,
shutoffwdve, fittings and instructions) is available
at extra cost flom your dealer or from Parts and
Ac( essories, 800-626-2002.
RefrigeratorLocation
Do not install the refiigerator where the
temperature will go below 60°F (16 ° C)
because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it
fiflly loaded.
Clearances
Allow the following clearan(es _br ease of
installation, proper air circulation and
plumbing and elecuical ( onne(tions:
Sides :
"
a/8 (15 ram)
Top l" (25 ram)
If bullt-ln, allow 7/8" {22 ram)for hinge covers.
If the refiigerator is against a wall
on either side, allow the fi)llowing
door (learan(es for a 90 ° door
opening:
22'- 25'models 3/4" (19ram)
27 models 172"(38 nun)
Back l" (25 ram)
Rollers
The moors have 3 purposes:
I-_] Rollers adjust so the door closes easily when
opened about hal_k_,ay.[Raise tile fiont about
,)/8 (1,) ram) fiom thefloor.]
To assure that tim doors Mll close automatically
fiom a halt_vay open position, there is a buih-in tilt
from the iiont to the back of the cabinet. Side-by-
side refligerators also have spe( ially designed door
binges that lift both doors slightly when opened,
allowing the fi)rce of gxavity to help (lose them
seolrely.
[_ Rollers adjust so the refligerator is firmly
positione(i on the floor and does not w(_bble.
[_ Rollers allox_ you to move the retiigerator away
fi'om tile wall'for (leaning.
To adjust the milers, remove tl_e base grille by pulling
it oil, a! the bottonL
Turn the roller adjusting screws c/ockwisetoraise
the refiigerator, ceuntemlockwise to lower it. Use
an adjustable wrend_ (3/8" hex head boh) or pliers.
iiii :
Toreplace base grille, align prongs on back of grille
with d_unps in (abinet and push forward until grille
snaps into place.
/7