GE Profile TFX27PFXFBB Owner's Manual page 33

Route the Copper Tubing and Connect it to the Shutoff Valve
Route tile topper tubing between tile (old'a ater line and the refl'igerator.
Route tile tubing through a hole drilled in the wall or floor (behind tile
reh'igerator or ac!jacent base cabinet) as close to tile wall as posfible.
Be.a/re tber_ is sufficient extra tubing [about 8 feet (244 cm) coiled ina 3 turns of about
70" (25 cm) diameterJto allow the refrigerator to move out tram the waft after installation.
Place tile compression nut and iermle (sleeve) onto tile end oithe tubing and
connect it to tile shutoff valve.
Make sm'e the robing is fldly inserted into the valve. Tighten tile compression
nut se(x_rely.
SaddleTypeShutoff V alve r-rt _'L_ Compression N ut
:;ll
OutletValve _rmle (sleeve)
Turn On the Water and Flush Out the Tubing
JTm'n the main water
supply
on and i]ush out the tubing until the water
i;, is (:lear.
JShut the _ater oil" at the _ater valve alier about one quart (1 I_) of water has
been flushed throngh the tubing.