GE AGM14 Owner's Manual And Installation Instructions page 5

GEAppliances.com
When the air conditioner is turned on, it will
automatically start in the last cool and fan
settings used.
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
COOLMode
Use the COOL mode with HIGH (F3), MED (E2)or
LOW(F1) fan for cooling. Use the INCREASE • /
DECREASEY pads to set the desired
temperature
between 60°F and 86°F in 1 °F increments.
A thermostat is used to maintain the room
temperature. _i11ecompressor will cycle on and off
to keep the room at the set level of comforL Set dm
thermostat at a lower number and the indoor air
will become coolen Set the thermostat at a higher
numix-r and the indoor air will become ,a_rmm:
NOTE: ff the air conditioner is off and is then turned on
while set to COOL, it will take approximately3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
ForNormal Cooling -Select
the COOL mode and
HIGH (F3) or MED (F'2)fan with a middle set
temperature.
FOrMaximum Cooling- Select the COOLmode
and HIGH(F3)t:an with a lower set temperature.
For Quieter & Nighttime Cooling- Select dm
COOL mode mad LOW(F1) Pan with a middle set
temperature.
NOTE: If youswitch from a COOL setting to OR:or to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use the FAN at HIGH (F3), MED (F2)or LOW (F1) to
provide air circulation and filtering without cooling.
Since tan only settings do not provide cooling,
a temperature setting will not be displayed.
VentControl
_ille vent control is located on the inside of the air
louvers on dm lower right side.
When set at CLOSE, only the air inside the room will
be circulated and conditioned. When set at OPEN,
some inside air is exhausted outside.
'lb open dm vent, pull the lever tow-ard you.
To close it. push it in.
Air Direction - Up and Down
Fingertip pressure on the bank of horizontal
louvers adjusts the air direction up or down.
5