Advertisement
5. Slide the border/edger tine
(A, Figure 1) on the right-hand
or left-hand side of the tine shaft.
Align the holes in the tine shoul-
der with the outer hole in the
shaft. Insert a clevis pin (D)
through the holes. Secure the cle-
vis pin with a hair pin clip (E).
Operation
WARNING
TO AVOID INJURY:
• NEVER operate the machine
when barefoot or when wear-
ing sandals, sneakers or other
lightweight footwear. ALWAYS
wear footwear that will protect
your feet and improve traction.
• NEVER carry the machine
when the engine is running.
Always shut the engine off
before transporting the
machine.
The Border/Edger Attachment
allows you to make clean, sharp
edges wherever grass meets a walk-
way, driveway, terrace, patio, or the
edges of planting beds. It's an
extremely handy landscaping and
yard care tool that attaches quickly
to your equipment.
For maximum edging performance:
• Keep the edger blade right up
against the surface of the material
you're edging against—the walkway,
driveway, patio, etc. See Figure 2.
• Keep the edger blade as vertical as
possible. In most cases you will
operate the unit's wheels on the
For customer assistance, visit www.troybilt.com, contact your nearest authorized dealer or:
TROY-BILT LLC, P.O. BOX 361131, CLEVELAND, OHIO 44136-0019, 1-866-840-6483
Printed in U.S.A.
NOTE: This means the shoulder of
the border/edger tine faces inward
toward the transmission housing.
6. Slide the wheel (C, Figure 1) on
the other end of the tine shaft. Then
slide the wheel spacer (B) on the tine
shaft. Insert a clevis pin (D) through
the shaft hole. Secure the clevis pin
with a hair pin clip (E).
Figure 2
walk, driveway or other hard surface,
but there will be instances (such as
edging along a curved surface) where
7. The Border/Edger attachment is
now installed and ready for use.
8. When edging jobs are complete,
remove the edger attachment and
reinstall the four tine gangs. Tighten
tine gang hardware securely.
Figure 3
you can achieve a better result if the
wheels are on the grass itself. Refer
to Figure 3.
Form 769-00132 (03/2002)
Advertisement
