Advertisement
Volume Control
This control sets the level of signal going to the amplifier output stage. The
further the control is turned to the right the less signal is required to drive the
amplifier to full output.
Tone Balance control
The tone balance allows the player to adjust the entire audio spectrum with
one simple control. The tone balance is a teeter totter type control. When the
Bass is turned up the level goes up in the bass ,shifts back to neutral across
the midrange and shifts lower in the treble ranges. The opposite happens
when the treble control side is turned up.
This control is very useful in rooms with unusual or bad acoustic
characteristics. For example in a room that is very dead or over damped ,
raising the treble level will allow the Bass to cut though better. If the room
has too much bass the same solution will be helpful. In a very live or
reverberant room turning down the treble will mellow out the Bass tone
quickly without upsetting your normal tone control settings.
Limit LED
This LED displays the amplifier maximum output condition and lets you
know that the amplifier has reached full output. It's fine for the LED to blink
often at high power operation . It should not however remain lit
continuously. This LED also indicates that the internal limiter is engaging.
Signal path switching ( Stereo, Dual Mono, Mono Bridged)
The WT-1000 has the input signal path switching on the front panel along
with indicator LEDs. This allows for an easy set up of the signal routing and
a highly visible display of the operating choices.
You can select Dual Mono (both channels see the same input), True Stereo
(each channel has its own input left and right), or Mono Bridged ( both
channels combine into one big channel and produce twice the power output).
You can operate in Bridged Mono @ either 8 ohms or 4 Ohms with this unit.
Advertisement
