Table of Contents
Advertisement
Initial Setup Instruction Guide
Power ON/OFF: Standby mode
- Press POWER
(
the side panel to turn on the unit.
[The power indicator changes from red to green]
- Press POWER
(
the side panel again to return the display to standby mode.
[The power indicator changes from green to red]
Selection of Input Mode
- Press the Input (AV/TV) button to display the signal source menu.
- Press
or
then press the Enter button to confirm.
When selecting the input source, the screen will display the information
of the selected input source. For example:
TV mode
-
When there is no signal from the selected source or channel, a warning message will be displayed.
-
If you see the "No Signal!" warning, you can select a different channel or press the Input (AV/TV)
button to change the selected source.
-
When you first receive your new TV, it is advisable to perform a new "Channel Scan" to setup your
set to receive all of the channels available in your area. Follow the section "Using Channel Scan"'
on page 15.
)
button on the remote control or on
)
button on the remote control or on
button to select the signal source you desire,
8
Advertisement
Table of Contents
