Table of Contents
Advertisement
Formatting
To format a P2 card or HDD, press the FORMAT button on the main screen. The device selection screen to be
formatted now appears.
A FORMAT SLOTS button
SLOT1 button/SLOT2 button/SLOT3 button/
SLOT4 button/SLOT5 button
These buttons can be used to select the P2 cards
inserted in any slot.
B FORMAT HDDS button
HDD1 button/HDD2 button/RAID1 button
These buttons can be used to select any of the
HDDs.
C START button
This starts the formatting.
D CLOSE button
Return to the main screen.
36
A
• Be careful when formatting media or devices.
Formatting will erase all data on P2 cards or HDDs.
• P2 cards cannot be formatted if the write-protect
switch is set to Protect.
The device is formatted by taking the following steps.
1
Select the device and press START button,
the FORMAT confirming screen will display.
2
Press OK button in this screen, the further
confirming screen will display.
3
Press OK button again and begin the
formatting.
Please understand that it can not be canceled
once the formatting begins.
The ending confirming screen will display after
formatting, press OK button to go back to the device
selecting screen.
If you press CANCEL button before formatting, you
can go back to the device selecting screen.
An error message is displayed if formatting is not
possible.
All the formats are FAT32. (The largest volume is limited
to 2 TB by the FAT32 format. Please understand it
when you install larger HDD in the future.)
B
C
D
Advertisement
Table of Contents
