To Adjust Brake; To Replace Motion Drive Belt; Belt Installation - Craftsman 917.270623 Owner's Manual

3ELT INSTALLATION
• Install new beltinreverse o rder o f
rem_ai._
• Make sure belt i sinallpulley grooves
andinside allbelt g uides.
• Install mower in reverse order of
removal instructions.
Idler
Pulleys
Mandrel
Pulley
Mandrel
Pulley
TO ADJUST_BR_AKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in high-
est gear, then brake must be adjusted.
• Depress clutch/brake pedal and engage
parking brake.
• Measure distance between brake oper-
ating arm and nut "A" on brake rod.
• If distance is other than 1-9116", loosen
jam nut and turn nut "A" until distance
becomes 1-9/16". Retighten jam nut
against nut"A'.
• Fload test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized ser-
vice center/department.
WithParkingBrake_'Engage@"
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
• Remove mower (See "TO REMOVE
MOWER" in this section of this manual.)
• Remove belt from stationary idler and
clutching idler.
• Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over cool-
ing fan blades.
• Pull belt toward front of tractor and
remove downward from around engine
pulley.
• Install new belt by reversing above pro-
cedure.
Engine
Pulley
Clutching
Stationan
Jam Nut
Transmission
Input Pulley
,+ _l'l'l'l'l'l'l'l'l_ "
Do _ touchthisnut. If furtherbrakeadjustment
is necessarycontactyournearestauthorizedser-
vice center/department
24