Advertisement
OPERATING INSTRUCTIONS cont.
Cleaning & Changing the
Dust Cup Filter
Warning:
Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important:
Do NOT use the hand
vacuum without the dust cup filter in
place.
Warning
After each Use - Always
:
remove and empty the Dust Cup Filter.
1. To open the Dust Cup (container),
push the dust cup release button
and detach the Dust Cup
(container). (Fig. 1)
2. Remove the dust cup filter. (Fig. 2)
Fig. 1
TROUBLE SHOOTING GUIDE
PROBLEM
POSSIBLE REASON
1.
Power cord not firmly plugged
HAND VACUUM
into outlet.
WILL NOT
2.
No power in wall outlet.
OPERATE
3.
Needs servicing.
HAND VACUUM
1.
Dust cup is full.
WILL NOT PICK-UP
2.
Unit clogged.
OR SUCTION
3.
Dust Cup Filter needs
POWER IS WEAK
cleaning or replacing.
1.
Dust cup is full.
DUST ESCAPING
2.
Dust Cup Filter is not
FROM HAND
installed correctly.
VACUUM
3.
There is a puncture/hole in
Dust Cup Filter.
HAND VACUUM
HOSE OR
1.
Hose clogged.
BRUSHES WILL
2.
Dust cup is full.
NOT PICK-UP
3. Empty the dust from the dust cup
(container).
4. Rinse the dust cup filter in cold water
and then wait 24 hours until it dries
completely before replacing back
into the dust cup (container).
5. When the dust cup filter is completely
dry, replace the dust cup filter carefully
back into the dust cup (container).
6. Attach the dust cup (container) to the
Hand Vacuum.
CAUTION
: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
Fig.2
POSSIBLE SOLUTION
1.
Plug unit in firmly.
2.
Check fuse or breaker.
Replace fuse/reset breaker.
3.
Call 1-800-798-7398.
1.
Allow unit to cool down, then
Restart. Empty dust cup –
(see page 4).
2.
Turn unit off and unplug
from wall outlet. Remove
Dust Cup Filter and check
for object(s) in air duct and
remove.
3.
Clean or replace Dust Cup
Filter. (see page 4)
1.
Empty dust cup.
2.
Review Dust Cup Filter
instructions. (see page 4)
3.
Replace dust cup filter. (see
page 4)
1.
Remove hose and/or
bushes. Remove obstruction
from hose.
2.
Empty and clean dust cup.
4
REPLACEMENT FILTERS
Replacement dust cup filter SKU# XSB031
for Model EP031
Call:
1-866-98SHARK (1-866-987-4275)
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
or
visit our website: www.sharkvac.com
FOR TECHNICAL SUPPORT
In U.S.: 800-798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
Please Note
The Dust Cup Filter is washable. It should, however, be replaced every three
(3) months to ensure peak performance of your vacuum.
Important
Make sure that Dust Cup Filter is completely dry before re-installing back
in the hand vacuum.
5
Advertisement
