Advertisement

Operating
Instructions
1000RB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1000RB and is the answer not in the manual?

Questions and answers

Summary of Contents for Gallien-Krueger 1000RB

  • Page 1 Operating Instructions 1000RB...
  • Page 2: Table Of Contents

    Table of Contents INTRODUCTION ………………………………………………………. 1000RB FEATURES ……………………………………………………. FRONT PANEL FEATURES …………………………………………… REAR PANEL FEATURES …………………………………………… HOOKING UP YOUR SPEAKERS …………………………………… GETTING YOUR SOUND ……………………………………………. TROUBLESHOOTING ……………………………………………….. USING EFFECTS ………………………………………………………...
  • Page 3: Introduction

    Introduction We are very proud of the 1000RB, G-K's most pow- The 1000RB is definitely not just another high power erful bass amplifier to date, and in many ways, the bass amp. Its High Current Capacity output stages- culmination of 27 years in the amplification busi- capable of delivering instantaneous power of 5,000 ness.
  • Page 4: Front Panel Features

    Front Panel Features (1) INPUT JACK (9) CONTOUR 1/4'' phone jack to plug in active or passive basses with a Voicing filter that boosts highs (4kHz) and lows (80Hz), while shielded cord dropping out mids (600Hz). Most players use this control (2) -10 dB PAD between half and maximum to create a "round"...
  • Page 5: Rear Panel Features

    Rear Panel Features Note : The block diagram of the 1000RB is printed on the rear (30) BAL. LEVEL panel and describes the signal flow from input to output. Many Adjusts signal level of balanced output (32). of your questions about the use and functions of the 1000RB are explained in this diagram.
  • Page 6: Hooking Up Your Speakers

    Hooking Up 4. CHECK TO SEE IF -10dB PAD IS REQUIRED Play a few notes and notice if the CLIP (3) LED stays on con- Your Speakers tinuously. If so, press the -10dB PAD(2) to prevent clipping in the input stage. The CLIP indicator should only light when you Before you power up your 1000RB, make sure your speaker cab- hit your loudest notes.
  • Page 7: Troubleshooting

    REPLACE CORD AND/OR BOOST2 RF2 DEFECTIVE REFER TO SERVICE TECHNICIAN NOT WORKING COMPONENT FAILURE REFER TO SERVICE TECHNICIAN GALLIEN-KRUEGER • 2240 PARAGON DR. • SAN JOSE, CA 95131 US: (408) 441-7970 • FAX (408) 441-8085 EUROPE: 41.42.234520 • FAX: 41.42.239525...
  • Page 8: Using Effects

    Putting effects in a "loop" results in much lower noise than "in line with the input". In a GALLIEN-KRUEGER • 2240 PARAGON DR. • SAN JOSE, CA 95131 US: (408) 441-7970 • FAX (408) 441-8085...

Table of Contents