Setting The Time And Language Displays - Oregon Scientific EMR898A User Manual

* These states have certain parts where a different time zone is
followed. Check to make sure to set the correct time zone for your
area.
** These states have certain areas where Daylight Savings are not
observed. In Hawaii, the whole state does not follow Daylight Savings.

SETTING THE TIME AND LANGUAGE DISPLAYS

Your clock is designed to automatically set itself using the radio signal
from the U.S. Atomic Clock. However, should you need to manually
set the clock without using the radio signal, follow the instructions
below. You can also choose your language for the weekday display
here.
Press or to adjust the values for each setting. To return
NOTE to normal clock mode, press the ALARM button anytime
during the procedures below.
We recommended that you disable the RF signal before
NOTE
manually setting the clock (→ p.15).
18
Page 20-21
EMR898_GB(02/05)
1. Press and hold MODE for 2 seconds.
Press MEMORY
2. Adjust the GMT difference according to
your timezone.
Press MEMORY
3. Choose between 12-hour or 24-hour
time formats.
Press MEMORY
4. Adjust the current hour.
Press MEMORY
5. Adjust the current minute.
Press MEMORY
6. Adjust the current year.
Press MEMORY
7. Adjust the current month.
Press MEMORY
8. Adjust the current date.
Press MEMORY
9. Choose the language for the day
of the week displayed.
Press MEMORY
10. Return to normal clock operation.
19
12/1/03, 10:36 AM
Adobe PageMaker 6.5C/PPC