Craftsman 358.360871 Instruction Manual page 13

• Keep thetreebetween youand the
chain.
• Remove larger branches withthe
cutting t echniques described in
BUCKING WITHOUT ASUPPORT.
• Always u seanovercut tocutsmall
and freely hanging l imbs. U ndercut-
tingcould cause limbs t ofalland
pinch thesaw.
PRUNING
z_
liWARNING: Limit pruning to limbs
shoulder height or below, Do not cut if
branches are higher than your shoul-
der. Get a professional to do the job.
• Make your first cut 1/3 of the way
through the bottom of the limb. This
cut will make the limb sag so that it
falls easily on the second cut.
• Next make the second cut an over-
cut all the way through the limb.
• Finish the pruning operation by using
an overcut so that the stump of the
limb protrudes 1 to 2 inches from the
trunk of the tree.
Second cut
__IFI ;Sto__a y
Third cut 1 to 2
inches from trunk
of tree
CUSTOMER RESPONSIBILITIES
_IiWARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
Fill in dates as you complete Before After Every Every Service
regular service Use Use 5 hrs. 25 hrs. Yearly Dates
Check for damaged/worn parts
Check for loose fasteners/parts
Check chain tension _"
Check chain sharpness _'
Check guide bar _'
Check fuel mixture level _'
Check guide bar and chain oil _'
Inspect and clean unit & decals _'
Check chain brake P"
Clean guide bar groove _"
Clean air filter _'
Clean/inspect muffler and spark s/
arresting screen
Replace spark plug and fuel filter _'
GENERAL RECOMMENDATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence, To re-
ceive full value from the warranty, the
operator must maintain unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically to
properly maintain your unit.
• Once a year, replace the spark plug,
air filter element, and check guide bar
and chain for wear, A new spark plug
and air filter element assures proper
air4uel mixture and helps your engine
run better and last Iongen
13