Storage; Troubleshooting - Craftsman WEEDWACKER C944.511110 Instruction Manual

_WARNIN6: Perform thefollow-
ingsteps
after each use.
* Stop the unit and disconnect the
power source when not in use.
* Carry the unit with motor stopped.
* Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.
TROUBLESHOOTING TABLE
,_WARNING: Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE CAUSE REMEDY
Trimmer head 1. Crowding trimmer line 1. Mow tip of line to do the cutting,
stops under a against material being
load or does not cut.
turn when switcl 2. Electrical failure. 2. Contact your Sears Service Centre.
is pressed. 3. Thrown circuit breaker. 3. Check Breaker Box.
4. Debris stopping head, 4. Remove debris,
Line does not 1. Line improperly routed 1. Check line routing.
advance or in head.
breaks while 2. Line improperly 2. Rewind line tightly and evenly,
cutting, wound into spool.
3. Incorrect line size 3. Use only 0,065 inch (1.65 mm) dia, line,
4. Not enouugh line 4. Remove cover and pull 4 inches
outside of head, (10 cm) of line out of head.
5. Dirt buildup on unit, 5. Clean unit.
Line welds onto 1. Line size is incorrect. 1. Use only 0.065 inch (1,65 mm) dia. line.
spool 2. Incorrect spool 2. Replace with correct spool.
3. Line is being crowded 3. Cut with tip of line fully extended.
against material being
cut.
Line releases 1. Line improperly 1, Check line routing,
continuously, routed in head,
2. Spool damaged. 2, Replace spool.
Line usage is 1. Line improperly routed 1, Check line routing,
excessive, in head,
2. Line size is incorrect. 2. Replace spool.
3. Crowding line against 3, Cut with tip of line fully extended,
material being cut,
4, Spool worn or damaged, 4, Replace spool,
Line pulls back 1, Too little line outside 1. Remove cover and pull 4 inches
into head. of head. (10 cm) of line outside of head.
2, Line size incorrect. 2. Use only 0,065 inch (1.65 mm) dia, line,
10