Advertisement
For p roper orientation
ofshield, see
KNOW
YOUR TRIMMER
illustration
inOP-
ERATION
section.
1. Remove
wing n ut f rom shield.
2. Insert bracket into slot asshown.
3. Pivot shield u ntil bolt p asses
through hole inbracket.
4. Securely
tighten wing n ut o nto bolt.
Shield
Bracket
/
/
Line Limiter
Wing
nut
Blade
KNOW YOUR TRIMMER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments.
Save this manual for future reference.
Assist Handle
Edge
Guide
Muffler
Throttle
ON/OFF
Trigger
Trimmer
Switch \
Spark Plug
Head
ON/OFF SWITCH
The ON/OFF switch is used to stop en-
gine. To stop the engine, move switch
to the OFF position.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
Choke Lever
Shield
Primer Bulb
Fuel Mix
Fill Cap
Line Limiter
Blade
CHOKE
The CHOKE helps to supply fuel to the
engine to aid in cold starting. Activate
the choke by moving the choke lever to
the FULL CHOKE position. After the en-
gine attempts to start, move the choke
lever to the HALF CHOKE position. Once
engine has started, move the choke le-
ver to the OFF CHOKE position.
EDGE GUIDE
The EDGE GUIDE protects the unit
from contacting
the ground during
edging.
BEFORE
STARTING
ENGINE
_LWARNING:
Be sureto
read
the fuel information
in the safety rules
before you begin. If you do not
understand
the safety rules, do not
attempt to fuel your unit. Call
1-800-235-5878.
FUELING
ENGINE
WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled
Advertisement
