Table of Contents
Advertisement
OPERATION
TO OPERATE
MOWER
(See Fig. 9)
Your tractor is equipped with an operator presence sensing
switch. Any attempt by the operator to leave the seat with
the engine running and the attachment clutch engaged will
shut off the engine.
•
Select desired height of cut.
•
Lower mower with attachment lift control.
•
Start mower blades by engaging attachment clutch
control.
•
TO STOP MOWER BLADES - disengage attachment
clutch control.
CAUTION:
Do not operate the mower
without either the entire grass catcher,
on mowers so equipped,
or the dis-
charge guard in place.
ATTACHMENT
CLUTCH
SWITCH
PULL OUT TO
"ENGAGE"
/
PUSH IN TO
"DISENGAGE"
ATTACHMENT
LIFT
LEVER
H!GH POSITION
i//
__JJf
__
_
POSITION
FIG. 9
TO OPERATE
ON HILLS
CAUTION:
Do not drive up or down
hills with slopes greater than 15 ° and
do not drive across any slope.
•
Choose the slowest speed before starting up or down
hills.
•
Avoid stopping or changing speed on hills.
•
If slowing is necessary, move throttle control lever to
slower position.
•
If stopping is absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
•
Move motion
control
lever to neutral
(N) position.
IMPORTANT:
THE
MOTION
CONTROL
LEVER
DOES
NOT RETURN
TO NEUTRAL
(N) POSITION
WHEN
THE
CLUTCH!BRAKE
PEDAL
IS DEPRESSED.
•
To restart movement, slowly release parking brake and
clutch/brake
pedal.
•
Slowly move motion control lever to slowest setting.
•
Make all turns slowly.
TO TRANSPORT
(See Figs. 9 and 10)
When pushing or towing your tractor, be sure to disengage
transmission
by placing freewheel control in freewheeling
position. Free wheel control is located at the rear drawbar
of tractor.
•
Raise attachment lift to highest position with attach-
ment lift control.
•
Pull freewheel control knob out and hold in position by
inserting retainer spring into forward hole of control rod.
•
Do not push or tow tractor at more than two (2) MPH.
•
To reengage transmission,
reverse above procedure.
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood is closed and
secured to tractor. Use an appropriate means of tying hood
to tractor (rope, cord, etc.).
J
FIG. 10
BEFORE STARTING
THE ENGINE
CHECK
ENGINE
OIL LEVEL (See Fig. 16)
•
The engine in your tractor has been shipped, from the
factory, already filled with summer weight oil.
•
Check engine oil with tractor on level ground.
•
Remove oil fill cap/dipstick and wipe clean, reinsert the
dipstick and push it all the way down into the tube, wait
for a few seconds,
remove and read oi! level.
If
necessary, add oi! until
"FULL" mark on dipstick is
reached.
Do not overfill.
•
For cold weather operation you should change oil for
easier starting (See "OIL VISCOSITY
CHART" in the
Customer Responsibilities
section of this manual).
•
To change engine oil, see the Customer Responsibili-
ties section in this manual.
14
Advertisement
Table of Contents
