Craftsman 536.270281 Operator's Manual page 8

Mid-engine rider 13.5 hp. electric start 30" mower/mulcher hydrostatic drive
Table of Contents

Advertisement

Available languages

Available languages

PREPARATION
MAINTENANCE
FREE BATTERY
4.
IMPORTANT:
Before
you attach
the battery cables to the
battery, check the battery date. The battery date tells if the
battery must be charged.
1.
Raise the seat support and secure in the UP position with the
seat support rod.
2.
3.
4.
Check the top of the battery for the location of the battery date
(Figure 1).
If the battery is put into service before the battery date, the
battery
cables can be attached without charging the battery.
See "How To Install The Battery Cables".
If the battery is put into service after the battery date, the
battery
must
be charged.
See
"How To Charge
The
Maintenance
Free Battery".
HOW TO CHARGE
THE MAINTENANCE
FREE BATTERY
_hlL
WARNING:
When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
1.
To disconnect the battery retainer from the battery tray, push
in on the lower end of the battery retainer.
2.
Remove the battery from the right side of the unit.
3.
Remove the protective caps from the battery terminals.
5,
Use a 12 volt battery charger to charge the battery. Charge at
a rate of 6 amperes for one hour. If you do not have a battery
charger, have a Sears or other qualified Service Center charge
the battery.
Install the battery and secure with the battery retainer. Make
sure the positive
(+) terminal
is on the right side.
HOW TO INSTALL
THE BATTERY
CABLES
_lb
WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable.
Use the fasteners shown below to install the battery cables. The
fasteners are attached to the battery cables.
(A)
2x82
(B)
14x79
1.
Remove the protective caps from the battery terminals.
2.
Fasten the red cable to the positive
(+) terminal
with the
fasteners as shown (Figure 1).
3.
Mount the battery
boot onto the positive
(+) terminal.
4.
Fasten the black cable to the negative (-) terminal with the
fasteners as shown.
Battery
A
Positive (+)
Terminal
A \
Red Cable
Battery Clamp
Black Cable
B
Figure 1
F-040601C
8

Advertisement

Table of Contents
loading

Table of Contents