Grounding Instructions; Optional Accessories - GE Profile SpacemakerXL JVM1350 Owner's Manual

Grounding [nsh uctions/Optiona{ Kits
PREFERRED
METHOD
Ensure proper ground
exists before use
WARNING--Improper
use of the grounding
plug can result in a risk
of electric shock.
This appliance must be grounded.
In the
event of an
electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an out-
let that is properly installed and
grounded.
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
If the outlet is a standard 2-prong
wall outlet, it is your personal
responsibility and obligation to
have it replaced with a properly
grounded 3-prong wall outlet.
Do not under any circumstances
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord with
this appliance. If the power cord is
too short, have a qualified electri-
cian or service technician install an
outlet near the appliance.
For best operation, plug this appli-
ance into its own electrical outlet to
prevent flickering of lights, blowing
of fllse or tripping of circuit breaker.
10
Available at extra cost from your
GE supplier.
Filler Panel Kits
JX4OWH--White
JX41--Black
JX4OAL--Almond
When replacing a 36" or 42" range
hood, this kit fills in the additional
width to provide a custom built-in
appearance. For installation
between cabinets only; not for
end-of cabinet installation. Each
kit contains two 3 -w_de filler pan-
els. Two kits are needed for a 42"
opening.
Filter Kits
JX81A--Recirculating Charcoal
Filter Kit
To be used when the microwave
oven cannot be vented to the
outside.
Decorative Panel Kit
JX22SS--Stainless Steel
When replacing a Hi/Low range,
this panel kit fills in the area
between the microwave and the
range left by the Hi/Low model.