Advertisement
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To
ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) 3/4" Socket w/drive ratchet
Utility knife
(1) 9/16" wrenches
Tire pressure gauge
(2) 1/2" wrenches
Phillips Screwdriver
When right or left hand is mentioned inthis manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVETRACTOR
FROM CARTON
UNPACK
CARTON
Remove all accessible loose parts and parts cartons
from carton.
Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat.
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING
TRACTOR
FROM
SKID
ATTACH
STEERING
WHEEL
(See Fig. 1)
ASSEMBLE EXTENSION SHAFT AND BOOT
Slide extension shaft onto lower steering shaft. Align
mounting holes in extension and lowershafts and install
5/16 hex bolt and Iocknut. Tighten securely.
Place tabs of steering boot over tab slots in dash and
push down to secure.
INSTALL STEERING WHEEL
Position front wheels of the tractor so they are pointing
straightforward.
Remove steedng wheel adapterfrom steering wheel and
slide adapter onto steering shaft extension.
Position steering wheel so cross bars are horizontal (left
to right) and slide inside boot and onto adapter.
Assemble large flat washer, 3/8 lock washer, 3/8 hex
bolt and tighten securely.
Snap steering wheel insert into center of steering wheel.
Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.
INSERT
----3/8
HEX BOLT
_......._3/8
LOCK WASHER
LARGE
FLAT
WASHER
STEERING
WHEEL
EXTENSION
SHAFT
5/16 HEX BOLT
SLOTS
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK
BATTERY
(See Fig. 2)
Lift seat pan to raised position and open battery box
door.
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in CUSTOMER RESPONSIBILITIES
section of this manual for charging instructions).
6
Advertisement
