Advertisement
SERVICE AND ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED"
position.
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE
MOWER
(See Fig, 17)
Mower will be easier to remove from the right side of tractor.
Place attachment clutch in "DISENGAGED"
position.
Move attachment lift lever forward to lower mower to its
lowest position.
Roll belt off engine pulley.
Remove small retainer spring, and lift clutch spring off
pulley bolt.
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
Disconnect anti-swaybar from chassis bracket by re-
moving retainerspring.
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
Disconnect front links from deck by removing retainer
springs.
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS AND HOOK THE CLUTCH
SPRING INTO SQUARE HOLE IN FRAME.
SMALL RETAINER
:
CLUTCH
TO INSTALL
MOWER
(See Fig, 17)
Raise attachment lift lever to its highest position.
Slide mower under tractor with discharge guard to right
side of tractor.
Lower lift lever to its lowest position.
install mower in reverse order of removal instructions.
TO LEVEL
MOWER
HOUSING
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See "PROD-
UCT SPECIFICATIONS" section of this manual). Iftires are
over or underinflated,
you will not properly adjust your
mower.
_ _ _
SQUARE
HOLE
SUSPENSION
ARMS
PULLEY
FRONT
LINK
RETAINER
SPRING.
ANTI-SWAY
SPRINGS
(BOTH SIDES)
HOUSING
GUIDE
LARGE
RETAINER
SPRING
BRACKET
Fig. 17
19
Advertisement
