Craftsman WEEDWACKER 358.799110 Operator's Manual page 27

f n Illnlmll I I I I IN IIII 1/1111111 II n m I IIIIIIIIII
QUICK REFERENCE PAGE
Read and Follow All Warnings, Safety Instructions, and Operating:Instructions.
Failure to do so ean result in serious injury, i
WARNINGS AND SAFETY INSTRUCTIONS ..........................
1. Know all warnings and safety instructions in this manual.
2. Wear safety face shield or goggles for eye protection.
3. Dress safely--boote or safety shoes and heavy,10ng pants.
4. Check unit for worn, loose, missing, or damaged parts;repair or replace as necessary before using unit.
5. Inspect and ensure the area to be cut is safe.
6. Keep children, bystanders, and animals 30 feet (10 meters) away.
3
FUELING ................................... .................. .. ....... 9
1. Eliminate all sources ofsparks or flame where fuel is mixed, poured, or stored.
2. USeengine3.2oilOZ.to2-Cycle,2.Sgal. air-cooled engine(9.5 I) reguhr unleaded°il to _ g_o_3e.81) regutar unleaded gasoline, OR, 8oz. 2-cycle, air -cooled
3. Use clean and fresh fuel.
4. Mix and store fuel in an approved, marked container.
5. Mix and pour fuel ]nan outdoor area.
6. Move a minimum of 10 feet (3 meters) away from the fuel and fueling site before starting the engine.
STARTING THE ENGINE ........................................... .. 10
1. Extend line 4 inches (10 cm) from the head.
2. Rest the shield on the ground supporting the trimmer head off the ground and away from objects and on-lookers.
3. Keep the throt_e _gger squeezed fully until engine nms. _i_ .
4. Pul! the _rropes_lyand _ckly. i i ; __
OPERATING THE UNIT 11 i
oooo o-oo_oooooeooooooo Iooe_io • _' "_i i
t QQ mo OQ €_O OOOOOO_
1. Do not operate the _t at ahigher speed_tha_necessary..
2. Release the throttle trigger and allow the engine to idle when not cutting.
3. Stop the engine by moving the ignition switch to the "Off" position.
MAINTENANCE • • • • • • ....... • • • .. .......... • • ...... :. .... . ............. 15
1. Have all maintenance other than the recommended procedures described in the Operator's Manual
performed by your Sears Service Center/Department.
2. Run fuel from the unit before storing.
3. Disconnect spark plug before performing maintenance except for carburetor adjustments .........................
.: 4. Clean air _ter frequently, but always afterShours of.operationor 5.tanks offuel, w_chever is less: ..........
5. Store unit in a dry place out of the reach of children.
.i- _i_ : _ '_' _ ..... _ _ i
J
irllllllim i i [ III II I I I Ilil INN [ I IIIII
_- 27,-