Washer Operation - Galaxy 11017122700 Use & Care Manual

Leaking
• Are the fill hoses tight?
• Are the fill hose gaskets properly seated? Check both
ends of each hose. See "Connect the Inlet Hoses" in the
Installation Instructions,
• Is the drain hose properly installed? The drain hose should
be secured to the drainpipe or laundry tub. See "Secure the
Drain Hose" in the Installation Instructions.
• Is the sink or drain clogged? Sink and drainpipe must be
able to carry away 17 gal. (64 L) of water per minute, If sink or
drainpipe is clogged or slow, water can back up out of
drainpipe or sink. Check household plumbing (laundry tubs,
faucets, drainpipe, water pipes) for leaks.
• Is water splashing off the tub ring? Center the tub before
starting the washer.
• Is water splashing off the load? Evenly distribute the load in
the washer basket and make sure the height of the load does
not exceed the top row of basket holes, The fill or spray
rinses can splash off the load.
Is the washer properly installed? The washer must be level.
The front feet should be properly installed and the nuts
tightened. Reset the rear leveling legs. See "Level the
Washer" in the Installation Instructions,
Dispenser operation
• Did you follow the manufacturer's directions when adding
detergent and fabric softener to the dispensers (on some
models)? Measure detergent and fabric softener. Slowly pour
into the dispensers. Wipe up all spills. Dilute fabric softener in
the fabric softener dispenser.
• Did you put powdered or liquid color-safe bleach into the
liquid chlorine bleach dispenser (on some models)? Add
powdered or liquid color-safe bleach directly to the washer
basket. Do not use the chlorine bleach dispenser for color-
safe bleach,
Is the fabric softener dispenser clogged? Clean the fabric
softener dispenser. See "Washer Care" for details,
Electrica_ Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or e_ectrical shock.
Washer won't run, fill, rinse or agitate; washer stops
• Is the power cord plugged into a grounded 3 prong
outlet? Plug power cord into a grounded 3 prong outlet.
• Are you using an extension cord? Do not use an extension
cord.
• Is the indicator on the Cycle control knob properly lined
up with a cycle? Turn the Cycle control knob to the right
slightly and pull to start.
• Are the water inlet valve screens clogged? Turn off the
water and remove inlet hoses from the washer. Remove any
accumulated film or particles. Reinstall hoses, turn on water
and check for leaks.
• Are both the hot and cold water faucets turned on? Turn
on the water.
Is the water inlet hose kinked? Straighten the hoses,
Does the water level seem too low, or does the washer
appear to not fill completely? The top of the agitator is
much higher than the highest water level. This is normal and
necessary for clothes to move freely.
Has a fuse blown, or has a circuit breaker tripped?
Replace the fuse, or reset the circuit breaker. If the problem
continues, call an electrician.
Is the washer in a normal pause in the cycle? The washer
pauses for about 2 minutes during certain cycles. Allow the
cycle to continue. Some cycles feature periods of agitation
and soak.
Is the washer overloaded? Wash smaller loads.
Is the lid open? The lid must be closed during operation.
Washer will not agitate or spin with the lid open,
Washer continues to fill or drain, cycle seems stuck
• Is the top of drain hose lower than the control knobs on
washer? The top of the drain hose must be at least 39"
(99 cm) above the floor. See "Drain System" in the Installation
Instructions.
Does the drain hose fit too tightly in the standpipe, or is it
taped to the standpipe? The drain hose should be loose yet
fit securely, Do not seal the drain hose with tape. The hose
needs an air gap. See "Secure the Drain Hose" in the
Installation Instructions,
2,''''''____
Washer won't drain or spin, water remains in washer
• Is the drain hose clogged, or the end of the drain hose
more than 96" (244 cm) above the floor? See "Drain
System" in the Installation Instructions.
• Is the lid open? The lid must be closed during operation.
Washer will not agitate or spin with the lid open.
• Is there excessive sudsing? Always measure detergent.
Follow manufacturer's directions. If you have very soft water,
you might need to use less detergent.
Wash/Rinse temperature
• Are the hot and cold water inlet hoses reversed? See
"Connect the Inlet Hoses" in the Installation Instructions.
• Are you washing many loads? As your frequency of loads
washed increases, the water temperature may decrease for
hot and warm temperatures, This is normal.