Frigidaire DGHS2634KB2 Use & Care Manual page 7

Top Hinge Top Hinge
Cover Front Cover Rear
Screw_ _.J Screw
Top Screw_ _ Hine£e Bk_tt_em_
Reoi Front
Cover Screw €0ver Screws
! _ I Cover
, O:
I1#--._ _ SCrews
\\--&\ ,op.,n e
Tools Necessary:
Phillips" Head
AND
To prepare for removing the doors:
3/8" Fixed
Wrench
Adjustable Hinge
To reinstall the refrigerator door, reverse the above steps.
To remove the freezer top hinge cover:
1 Remove the two screws from each cover over the top door hinges.
2 Lift hinge cover straight up and off.
Front
Reor
Cover Screws C vet Screw
T°cPveHi nge _._o j_..
Hinge __
Mo,t,-W,re o-! )//
4 -'7 .Ing°
TO DISCONNECT
1. Press outer ring against face
remove tube
oush until mark touches face of fitting
Be sure doors are set aside in a secure position where they cannot fall and cause
personal injury.
To remove the freezer door:
1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides of
the connector firmly and pull apart.
2 Trace lightly around the hinge with a pencil. This makes reinstallation easier.
3 Detach the water tube from the connector located below the freezer door. The connector
releases when you press its outer sleeve inward.
4 Remove the screws from the top hinge and pull the multi-wire cable through it. Lift the
door off of the bottom hinge.
Remove the two bottom hinge screws and hinge if necessary.
Lay the door on its side to avoid damage to the water tube extending from the bottom hinge.
5
6
To reinstall the freezer door, reverse the above steps.
(
Adjustable Hinge (some models)
Tubing
Hinge
Assembly
Non-Adjusting Hinge
(some models)
To remove the refrigerator top hinge cover:
1 Remove the three screws from each cover over the top door hinges.
2 Lift hinge cover straight up and off.
To remove the refrigerator door:
1 Trace lightly around the door's top hinge with a pencil. This makes reinstallation easier.
2 Removethe two screws from the top hinge. LA the door off of the bottom hinge and set it aside.
3 Remove the two bottom hinge screws and hinge if necessary.
1 Make sure the electrical power cord is unplugged from the wall outlet.
2 Open both doors and remove the toe grille (as explained in the Installation Instructions
that came with your appliance).
:3 Remove any food from the door shelves.
4 Close the doors.