Advertisement
CLEANING
i Clean engine, battery, seat, finish, etc.
of all foreign matter.
Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden
hose to clean your tractor unless the elec-
trical system, muffler, air filter and carbure-
tor are covered to keep water out. Water
in engine can result in a shortened engine
life.
CAUTION:
Before performing any service or adjustments:
• Depress clutch/brake pedal fully and set parking brake.
• Place motion control lever in neutral (N) position.
• Place attachment clutch in =DISENGAGED"
position.
• Turn ignition key "OFF" and remove key.
• Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TRACTOR
TO REMOVE
MOWER
• Place attachment
clutch in "DISEN-
GAGED" position.
• Turn height adjustment
knob to lowest
setting.
• Lower mower to its lowest position.
• Remove retainer spdng holding anti-
swaybar to chassis bracket and disen-
gage anti-swaybar from bracket.
• Remove retainer spdngs from suspen-
sion arms at deck and disengage
arms
from deck.
• Raise attachment
lift to its highest posi-
tion.
Adjustment Lift
Suspension Nuts
Links
Arms
Chassis
i
• Remove two retainer springs from each
front link and remove links.
• Slide mower forward and remove belt
from electric clutch pulley.
• Slide mower out from under right side of
tractor.
iMPORTANT:
If an attachment other than
the mower deck is to be mounted on the
tractor, remove the front links.
TO iNSTALL
MOWER
Follow procedure described in =INSTALL
MOWER
AND DRIVE BELT" in the
Assembly section of this manual.
Front Suspension
Bracket
Electric
Clutch
Pulley
Suspension
Bracket
Retainer
Spring
Anti-Sway
Bar
Retainer
Springs
Retainer
Springs
Front
Mower
Bracket
23
Advertisement
