Scupper Pro Rudder Installation Instructions (1997 or newer models)
This kit is designed for the Scupper Pro with rudder mount and notches, first shipped October 29, 1996, serial numbers greater than XKA11274. Your Pro must
14561
BOW
Parts Included:
1 rudder assembly (300386)
2 steering tracks with slides and pedals
(300107)
2 lengths of tubing (300153)
2 steering lines (300084)
1 nylon sleeve (300077)
4 long machine screws (300163)
4 well nuts (300162)
Drill Tubing Holes
1. You must first drill holes at the center of each notch (3, 4, 5, 6). Hold the drill at 90 degrees to the vertical surface
of the notch, and hold it tightly to keep the drill straight through the layer of plastic.
2. Smooth any rough patches where you have drilled. Insert each of the 4 rubber grommets into each of the drilled
notches. Tubing and steering lines will run through the kayak at these points.
also have the front and center hatches to allow acess to the hull for rudder installation.
Ledge (for
steering track)
6-inch hatch (needed
to install steering lines)
1
Ledge (for
steering track)
1 clam cleat (300099)
1 strap eye (300048)
2 adhesive-backed strap eyes (for 2-hatch Pro)
(300104)
4 self-tapping screws (300036
2 short machine screws (300110)
4 rubber grommets (300097)
Call your local dealer or Ocean Kayak if you have questions. 800-8-KAYAKS or 360-366-4003. Or e-mail service@oceankayak.com.
Notch (vertical surface for
tubing and steering lines)
2
3
4
Notch (vertical surface for
tubing and steering lines)
Notch (vertical surface for
tubing and steering lines)
6
STERN
5
Notch (vertical surface for
tubing and steering lines)
Tools Needed:
drill
hammer
small block of wood
3/8" drill bit
7/16" wrench
soapy water
knife
duct tape
stiff wire (for TW)
phillips screwdriver
pen or marker
Rudder mount
(insert nylon sleeve)
7