Advertisement
4. To shut the unit down, rotate the humidity knob to the OFF position.
Note: the fan will remain on for a short time to remove moisture
from the internal coils.
While the unit is plugged in the power indicator
will remain lit. Only removing
the
plug will extinguish
this light.
REMOVING
COLLECTED
WATER
1. Emptying
the Bucket:
a. When the bucket is full the unit will shut down and the BUCKET
FULL
indicator light will illuminate.
b. Do not move the unit at this point otherwise
water may spill on the floor.
c. Press sides of bucket gently to unciip the bucket from the unit.
d. Remove
the bucket as shown in the photographs
below and empty the
bucket.
{./
e. Replace the empty bucket back into the unit and once seated correctly
the unit wiB start up again.
f.
You should hear a dick when the bucket is in the correct position
If the bucket full light does not extinguish,
check that the float is correctly
snapped
in place as indicated
by the diagram.
Advertisement
