Removing Collected Water
1. Emptying the Bucket:
a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.
b. Do not move the unit at this time otherwise water may spill on the floor.
c. Press sides of bucket gently to unclip the bucket from the unit.
d. Remove the bucket as shown in the photographs below and empty the bucket.
WARNING
Discard water from bucket. Water is not potable and cannot be used for drinking.
e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.
f. You should hear a click when the bucket is in the correct position
If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram.
NOTE:
The foam embedded under the float(shown in the diagram below) is a functional part, which can not be removed.
2009 Electrolux Home Products, Inc.
CLEAN FILTER
LOCK
TIMER
FILTER
TIMER
SPEED
HIGH
65
MEDIUM
LOW
_
+
FAN
Operating Instructions
SLEEPING SPACE
BUCKET FULL
LIVING SPACE
CONTINUOUS
BASEMENT
CONTI
MODE
NUOUS
All rights reserved.
POWER
7
Need help?
Do you have a question about the Dehumidifier and is the answer not in the manual?
Questions and answers