Advertisement
D. Loosely assemble the sill supports.
Indoor
Outdoor
\Nut
Fig. 23
E. Select the position that will place the sill
supports near the outermost point on the
sill. Attach the sill supports to the case
track hole in relation to the selected
position using 4 type C screws in each
supports.
F. Adjust the bolt and the nut in each support
so that the case is installed with a slight tilt
to the outside. Use a level; about 1/3" will
be the correct case slant to the outside.
G. Secure the case to the window stool by using
6 type B screws.
H. Pull the accordion panels to each window
sash track. Attach them on each side to
the window sash and the window stool
using 5 type B screws.
Fig. 24
Sill support_
Fig. 25
J
Fig. 26
A. Cut the foam top window gasket to the
window width.
B. Stuff the foam between the glass and
the window to prevent air and insects
from getting into the room.
Fig. 27
14
Advertisement
