Advertisement
i
Cyde
Signal
Control
(some models)
When the Cycle Signal Control is ON, a signal will sound at the end of each cycle
and during the PressSaver setting (some models). The volume isadjustable on some
models.
Drum
Light
(some models)
A dru m light will come on whenever the door isopened to illu minate the dryer dru m
during loading and unloading. Closing the door turns off the light.
Placethe front bar under
the lip of the lint screen opening
Reversible
Dryer
Door
Your dryer is equipped with a reversible door. The door can be hinged on the right
or left side. Refer to tile INSTALLATION INSTRUCTIONSfor directions on changing
tile door.
Drying
Rack (some models)
Use the drying rack to dry items which should not be tumble dried.
1. Open the dryer door and remove the lint screen.
2.
Insert drying rack into tile dryer drum. Place tile front bar under the lip of the
lint screen opening.
3.
Place items to be dried on top of the rack. Weight should not exceed !0 Ibs.
Leavespace between items, but do not let items hang over the sides or through
the grids. Do not tumble other items when using the drying rack.
4.
Select a timed dry setting best suited for items being dried. Use only the Air Fluff
(no heat) temperature setting for items containing plastic, foam rubber, rubber-
like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint screen
is not in place, tumbling
items could enter the exhaust system and cause
damage to tile dryer.
i
Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage.
For satisfactory drying results, follow these suggestions provided by Tile Soap and Detergent Association.
Greasy,
oily
stains
Lint
POSSIBLE CAUSES
PREVENTIVE MEASURES
• Fabricsoftener sheet,
,
Rubfabric softener stainswith bar soap,
,
Add a few bath towels to small loadsfor
Rinseand rewash,
proper tumbling
Some "silkdike" fabrics should be air dried,
Useproper
drying temperature_
Placefabric softener sheet
on top
of load
before
starting
the dryer
Do not overload
dryer
Usefabric softener in washer
or
dryer to
reduce static
electricity
Removeitems when they are slightly damp
to avoid overdrying.
Check that lint screen is cleanand in place.
Pilling
(Fibers break
off, ball up and
cling to fabric.)
Shrinking
Wrinkling
Overloading_
Overdrying
causes static
electricity.
Lint screen not clean
when cycle begam
Lint is attached
to "pills_"
Reduceload size and rewash using liquid .
fabric softener in the final rinse_
Or,
add a fabric softener sheet and
tumble without heat
Use lint brushor roller to remove lint,
Pilling is normal with
synthetic and permanent
press fabrics This is due
to abrasion from normal
wear_
Use a lint brush or shaver to remove pills.
Use fabric softener to lubricate fibers
When ironing, use spray starch or fabric
finish on collars and cuffs_
Turn items inside out to reduce abrasion
Overdrying
Overloading.
Leaving items in dryer
after cycle ends
Irreversible condition
Reduce load size and tumble
at medium
or low heat for 5-10 minutes_
Remove items immediate[y_
Hang or fold.
Follow
fabric care label directions
If shrinking
is a concern,
check
load often.
Remove items while slightly
damp
and
hang or lay fiat to complete
drying_
Block knits into shape
Do not overload
dryer
Remove items as soon as cycle ends
Advertisement
