Cycle Settings - Frigidaire FRQE7000LW0 Use & Care Manual

Cycle Settings
For best results
Follow the fabric care label instructions
on items to be dried.
Appropriate dryness level and options will automatically
be displayed for each cycle. The settings can be changed
before the cycle is started.
If changes are attempted after the cycle starts, the lights
will blink and the signal will beep.
Drying Temperature
Turn the temp knob until the desired dwing temperature
is selected. If the drying temperature is not appropriate
for that cycle, the status lights will blink and the signal
will beep 3 times. To protect your fabrics, not all
temperatures are available with every cycle.
To change the temperature once the cycle has begun,
press the pause/cancel button once, make the new
selection and press START again.
high
Recommended for most cotton fabrics.
normal
Recommended for wrinkle free, easy care, lightweight
fabrics and bulky loads.
low
Recommended for delicate fabrics.
air dry
This setting (no heat) should only be used with a Timed
Dry cycle to dry items containing feathers, down, foam
rubber, plastics or rubber-like materials; to refresh clothing,
stuffed animal, pillows or blankets; and to dust draperies.
Dryness Level (Auto Dry)
To change the preset level, press the dryness button to
scroll to the degree of dryness desired.
To protect your fabrics, not all dryness levels are available
with every cycle. If a dryness level is not appropriate for
the cycle, it cannot be selected.
The dryness level selected for the cycle will be
remembered and recalled each time that cycle is selected
in the future. To return to factory settings, press the
pause/cancel and select buttons at the same time and
hold until the signal sounds.
To change the dryness level once the cycle has begun,
press the pause/cancel button once, make the new
selection and press START again.
Select the normal dryness level for most Auto Dry cycles.
Occasionally a load may seem too damp or over-dried at
the end of the cycle. To increase drying time for similar
loads in the future, select high. For loads requiring less
drying time, select low.
Select damp for items you wish to partially dry before
hanging or ironing.
Options
To select an option, press options until the indicator
for the desired option flashes, then press select. If an
option is not available for a cycle, the indicator will not
light. Follow the same steps to delete an option.
To change the option once the cycle has begun,
press the pause/cancel button once, make the new
selection and press START again.
wrinkle release
Select wrinkle release if the dried load might not
be removed promptly at the end of the cycle. The dry
load will continue tumbling without heat to help reduce
wrinkling. When the cycle signal is selected, a beep
will be heard periodically. The load may be removed
any time during wrinkle release.
cycle signal
A signal will sound at the end of the cycle (and
periodically during wrinkle release) if this option is
selected.