Advertisement
TRANSAXLE
COOLING
RESIPONSR
The fan and cooling fins of transmission should be kept
clean to assure proper cooling,
Do not attempt to clean fan or transmission while engine is
running or while the transmission
is hot.
To prevent
possible damage to seals, no not use high pressure water
or steam to clean transaxle.
•
Inspect cooling fan to be sure fan blades are intact and
clean.
=
Inspect cooling fins for dirt, grass clippings and other
materials.
To prevent damage to seals, do not use
compressed
air or high pressure sprayer,
TRANSAXLE
PUMP FLUID
The transaxle was sealed at the factory and fluid mainte-
nance is not required for the fife of the transaxle,, Should
the transaxle ever leak or require servicing, contact your
nearest authorized service center/departmenL
V-BELTS
Check V-belts for deterioration and wear after 100 hours of
operation
and replace if necessary,
The belts are not
adjustable
Replace belts if they begin to slip from wear
ENGINE
LUBRICATION
Only use high quality detergent oil rated with APt service
classification S F or SG, Select the oil's SAE viscosity grade
according to your expected operating temperature,
SAE VISCOSITY GRADES
°F
-20 _'
0'_
30"
32"
40 _
60 _
80 _
100 _'
°c .3o o
-_o,,
-10o
oo
1'o°
=o°
30°
40°
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
NOTE:
Although muttFviscosity oils (5W30, 10W30 etc,)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
32°F. Check your engine oi! level more frequently to avoid
possible engine damage from running low on oil
Change the oil after the first two hours of operation and
every 50 hours thereafter
or at least once a year if the
tractor is not used for 50 hours in one year,
Check the crankcase oil level before starting the engine
and after each eight (8) hours of operation
Tighten oil fill
cap/dipstick securely each time you check the oil level,
LUTUES
TO CHANGE ENGINE OIL (See Fig 17)
Determine temperature range expected before oil change_
All oil must meet API service classification
SF or SG
o
o
o
o
°
o
Be sure tractor is on level surface.,
Oil will drain more freely when warm,
Catch oil in a suitable container
Remove oil fill cap/dipstick,
Be careful not to allow dirt
to enter the engine when changing oil..
Remove drain plug.,
After oil has drained completely, replace oil drain plug
and tighten securely,,
Refill engine with oil through oil fil! dipstick tube. Pour
slowly. Do not overfill
For approximate capacity see
"PRODUCT
SPECIFICATIONS"
on page 3 of this
manual°
Use gauge on oil fill cap/dipstick for checking level. Be
sure dipstick is in all the way for accurate reading,
Keep oil at "FULL" line on dipstick
OIL DRAIN PLUG
ENGINE OIL
FILLER CAPIDIPSTICK
FIG. 17
CLEAN
AIR SCREEN
(See Fig. 18)
Air screen must be kept free of did and chaff to prevent
engine damage from overheating
Clean with a wire brush
or compressed air to remove dirt and stubborn dried gum
fibers
19
Advertisement
