Craftsman 486.24338 Owner's Manual page 5

Assemble the axle bracket to the angle brackets using
two 5/16" x 3/4" hex bolts and 5/16" hex lock nuts.
The ends of the axle bracket must point as shown in
figure 2. Tighten and then loosen the nuts slightly.
Tighten the nuts fastening the angle brackets to the
tray.
5/16" x 3/4"
5/16" HEX HEX BOLT
LOCK NUT
FIGURE 2 REAR VIEW
Assemble the ends of the hitch mount arms to the
hitch arm mount brackets at the rear of the tray.
Fasten to the outside of the brackets using two 5/16"
x 3/4" carriage bolts, 5/16" lock washers and 5/16"
hex nuts. Do not tighten yet. See figure 4.
5/16"
HEX 5/16" LOCK
NUT WASHER
5/16" x 3/4"
CARRIAGE BOLT
FIGURE 4 REAR VIEW
Assemble the wheels to the axle bracket using a
spacer, a 3/8" x 2-1/2" hex bolt, a 3/8" flat washer and
a 3/8" hex lock nut for each wheel. Tighten. See
figure 3.
3/8" x 2-1/2" 3/8" HEX
HEX BOLT LOCK NUT
SPACER
3/8" FLAT
WASHER
FIGURE 3
REAR VIEW
Assemble two angle brackets to the holes in the
bottom at the front of the tray. Use two 5/16" x 3/4"
hex bolts and 5/16" hex lock nuts. Do not tighten yet.
See figure 5.
HEX
LOCK NUT /
5/16" x 3/4"
HEX BOLT
FIGURE 5 FRONT VIEW