Craftsman WEEDWACKER 358.795500 Instruction Manual page 15

1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion RCJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4. Reinstall the spark plug boot.
LINE REPLACEMENT
Pre-wound spools offer the most con-
venient method for replacing line and
ensuring optimum performance.
* Replacement spools are color-
coded to ensure use of the correct
spool with your unit. Be sure to use
the same color spool as the existing
spool.
NOTE: Always clear dirt and debris
from cutting head components when
performing any type of maintenance.
* Hold spool andunscrew cap by turn-
ing in the direction shown on top of
the cap.
* Remove line guide ring and spool.
Line guide ring
Cap \
Use a pre-wound spool or refill spool
with line. If using a pre-wound spool,
remove tape strip from line and spool.
REFILLING THE SPOOL WITH LINE
i_ WARNING: Use only 0.080
inch (2 mm) diameter round line.
Other sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious in ury. Do not use other
mater a s such as w re, str ng, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
1. Cut a length of 25 feet of 0.080
inch (2 ram) diameter round
Craftsman brand line.
_> Feeedtiiionn e in
on
Spool
2. insert one end of line into center
cavity of empty spool. Ensure line
will feed into spool in the direction
shown on the spool (counterclock-
wise).
3. Continue feeding line into spool,
leaving 4 - 6 inches (10 - 15 cm)
unwound from center of spool.
INSTALLING SPOOL WITH LINE
1. Install replacement spool.
2. Thread line through line guide ring.
Line through guide ring 1
Sio
Replacement Spool
3. Rest guide ring on spool and place
line through slot. Allow line to ex-
tend 4 - 6 inches (10 - 15 cm)
from center of spool.
4. Ensure line remains in slot while
screwing cap on to the shaft.
Only tighten cap hand tightI
CARBURETOR ADJUSTMENT
i_ WARNING: Keep others away
when making idle speed adjustments.
The trimmer head or any optional at-
tachment will be spinning during most
of this procedure. Wear your protec-
tive equipment and observe all safety
precautions. After making adjust-
ments, the trimmer head or any op-
tional attachment must not move/spin
at idle speed.
15