Yard-Man 247.270170 Operator's Manual page 10

Align the
holes on the hitch plate with the holes
on the rear frame assembly as shown in Figure
6C. Secure on each side with hex bolt, lock
washer and hex nut from the hardware pack.
rame
Cove n"
"_ Screw
B
Lock L ,.._,
Gea ,:.._
:C
Hitch Plate ._._(
Rear
Frame _
_1_ /// /
_ _t ¢ _ °Cker
' 3: _- Hex
Figure 6
Attaching Steering Shaft
• Slide the steering shaft over the steering tube
and secure with three self-tapping screws from
the hardware pack. See Figure 7.
_Steerlng Shaft
Secure with '
_ self-tapping screw
Attaching Control Knobs
• Attach control knobs to the shift lever and
throttle/choke control lever using truss head
machine screws and hex nuts. See Figure 8.
0==-1 - _ _ Control Knob
Figure 8
Attaching Steering Wheel
• With the wheels of the tractor pointing straight
forward, place the steering wheel over the
steering shaft, positioning the steering wheel as
desired. See Figure 9.
• Place the bell washer with the cupped side
down over the steering shaft. Secure with hex
lock bolt.
• Press the steering wheel insert onto the
steering wheel aligning the four tabs in the rear
of the steering wheel insert with the four slots in
the steering wheel so that the cap fits snugly.
See Figure 9.
He]( Lock Bolt
Steering _sher
Wheel
Steering
..._.i Shaft
Steering Wheel
Insert
J
Figure 7 Figure 9
10