Craftsman 358.351040 Operator's Manual page 22

SERVICE AND ADJUSTMENTS
• Pullout 10" of rope and catch rope in tab in the pulley.
• Carefully turn the pulleytwo completeturnsclockwise,
keeping the rope against the tab to wind the spring.
• While holding the pulley ratchet, pull the excess rope
throughthe starter rope hole.While holdingtension on
the rope, let rope slowly rewind intothe housing.
--L_
Wind Up Spring
Rewind fo_4_r
Tension
• Reinstallfan housing by aligning the fan housing to
the chassis. Then while holding the fan housing
against the chassis, pull the rope handte out until you
feel the fan housing drop into place against the chas-
sis. Slowly,let the rope rewind into starter housing.
• Reinstallthe 4 fan housingscrews and tighten the 2
cylindercover screws.Fig 45.
Figure 49
-22-