Table of Contents
Advertisement
DESCRIPTION
Ground wire
• The ground wire (G) reduces static
beNd-up during operation in dry condb
tions.
!
Inlet cover
• An inlet cover (H) is located on the side
of the fan housing•
Opening
this cover
allows access
for cleaning
and inspect-
ing the impe,er
(125Bx SERIES and
125BVx SERES only). If the vacuum
tube
is used. it must be fitted to the opening
in
the inlet cover• To open the inlet cover.
use a tool to lift the edge of the cover
opposite
the hinge (indicated
by arrow
on inlet cover).
H
j•
WARNING:
Never start the blower
if the inlet cover
is not closed,
is
damaged
or cannot
be closed
(except if the vacuum
tube is fitted).
Cutter8
(125BX_SERIES and 125BVx_sERIES)
• Two cutters (J) are fastened to the impeF
lee The cutters are there to mulch leaves
and other debris that have been vacuumed
before they enter the collection bag.
Blower
tube
and
nozzle
NOTE:
The tube clamp bolt and nut must
be insta,ed
prior to initial use (see the gen-
eral description
of the blower
on page 6)
• The blower tube (K) has a begged slot
mounting system to the unit
To install or
remove the bbwer tube (or co,ecf_3n bag
tube for the 125BVx SERIES). the tube
clamp bolt must be removed•
Align slot in
the bbwer air outlet with the raised rib on
the tube and insert tube until the holes in
the tube and housing align. Re-insert
the
tube clamp bolt and tk:jhten.
• The nozzles
(L) have a bayonet
mount
for connection
to the blower tube• Air is
channeled
through
the blower
tube to the
nozzles,
where the air discharge
velocity
increases and the air stream discharge
pattern
is formed to prov{de best perfor-
mance.
The length of the blower tube
can be adjusted
by twisting the nozzle to
the left to disengage
the bayonet mount
and sliding the nozzle to the appropriate
position.
Twist the nozzle to the right until
a click is fed to resecure
the nozzle
K
Starter
device
and
8tarter
handle
• The starter device
(M) is located on the
side of the engine shrouding
and en-
gages the crankshaft
only when the
starter handle (N) is pulled.
_%...
j rt" '2
Fuel
cap
• The fuel cap (O) is located at the rear of
the engine shrouding
on the fuel tank
and has a seal to prevent fuel from leak-
ing out.
j'
L%
Air filter
• The air filter (P) consists
of a fiber filter
medium
in a resilient
frame. The air filter
should
be cleaned
at specific
intervals
(see Maintenance
section).
Otherwise,
the blower
will consume
too much fuel.
the performance
win be reduced
and an
oily deposit
may form on the spark plug
electrodes•
545154658
Rev. 5
7/15/08
English-g
Advertisement
Table of Contents
