To Start Engine With A Weaak Battery; To Adjust Steering Wheel Alignment; Front Wheel Toe-In/Camber; To Remove Wheel For Repairs - Craftsman 917.271833 Owner's Manual

Gearshift Lever Neutral
Lock Gate
Adjustment
Bolt
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not
horizontal (left to right) when wheels are
positioned straight forward, remove
steering wheel and reassemble per
instructions in the Assembly section of this
manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjustable on your tractor. If damage has
occurred to affect the front wheel toe-in or
camber, contact a Sears or other qualified
service center.
TO REMOVE WHEEL FOR REPAIRS
1. Block up axle securely.
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).
3. Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle.
Insert square key.
4. Replace washers and snap retaining
ring securely in axle groove.
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
Washers
Retaining _
Ring
Axle Cover \
Square Key _"
(Rear Wheel Only)
TO START ENGINE WITH AWEAK
BATFERY
_;I,CAUTION: Lead-acid batteries generate
explosive gases. Keep spades,flame and
smoking materials away from batteries.
Always wear eye protectionwhen around
batteries.
If your batteryis too weak to startthe engine, it
shouldbe recharged. (Sea "BA'I-rERY" in the
MAINTENANCE sectionof this manual).
If "jumper cables"are used for emergency
starting,follow this procedure:
IMPORTANT: Your tractoris equipped with a
12 volt negative groundedsystem. The other
vehical must also be a 12 volt negative
groundedsystem. Do not use your tractor
battery to startothervehicles.
TO AI-rACH JUMPER CABLES -
1. Connect each end of the RED cable to
the POSITIVE (+) terminal of each
battery, taking care not to short
against chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
"Positive" (+) =Negative" (-)
26