Advertisement
Available languages
Available languages
TROUBLESHOOTING
TABLE
- Continued
TROUBLE
CAUSE
REMEDY
Oil inadequate
1. Oil tank empty.
1. Fill oil tank.
for bar and
2. Oil pump or oil filter
2. Contact Sears Service.
chain
clogged.
lubrication.
3. Guide bar oil hole
3. Remove bar and clean.
blocked.
Chain moves at 1. Idle speed requires
1, Sea "Carburetor Adjustment" in the
idle speed,
adjustment.
Service and Adjustments Section.
2. Clutch requires repair.
2. Contact Sears Sen/ice.
chain does not
move when en-
gine is acceler-
ated.
Chain clatters
or cuts roughly.
Chain stops
within the cut.
Chain cuts at
an angle.
1. Chain tension too
tight.
2. Carburetor requires
adjustment.
3. Guide bar rails
pinched,
4. Clutch slipping.
5. Chain brake engaged,
1. Chain tension incorrect.
2. Cutters damaged.
3. Chain wom.
4. Cutters dull, improperly
sharpened, or depth
gauges too high.
5. Sprocket worn.
6. Chain installed
backwards.
t. Chain cutter tops not
filed flat,
2. Guide bar burred or
bent; rails uneven.
3. Clutch slipping.
1. Cutters damaged on
one side.
2. Chain dull on one side.
1 : See =Check Chain Tension" in the
Maintenance Section.
2. See =Carburetor Adjustment" in the
Service and Adjustments Section,
3, Repair or replace.
4. Contact Sears Service.
5. Disengage chain brake.
1. See =Check Chain Tension" in the
Maintenance Section.
2. Contact Sears Service.
3. Resharpen or replace chain.
4. See "Chain Sharpening" in the
Service and Adjustments Section.
5. Contact Sears Service.
6. Install chain in right direction.
1.
2.
3.
See "Chain Sharpening" in the
Service and Adjustments Section.
Repair or replace guide bar.
Contact Sears Service.
1. See =Chain Sharpening" in the
Service and Adjustments Section.
2. See "Chain Sharpening" in the
Service and Adjustments Section.
3. Guide bar bent or worn.
3. Replace guide bar.
If situations occur which are not covered in this manual, use care and good
judgement.
If you need assistance,
contact Sears Service or the CUSTOMER
ASSISTANCE HELPLINE at 1-800-235-5878.
YOUR WARRANTY
RIGHTS
AND OB-
UGATIONS:
The U.S. Environmental
Protection Agency/California
Air Re-
sources Board and Sears, Roebuck and
Co., U.S.A.,
are pleased to explain the
emissions control system warranty on
your year 2000-2003
small off-road en-
gine. In California, all new small off-road
engines must be designed, built, and
equipped to meet the State's stringent
anti-smog
standards. Sears must war-
rant the emission control system on your
small off-roed engine for the periods of
time listed below provided
there has
been no abuse, neglect, or improper
maintenance of your small off-road en-
gine engine. Your emission control sys-
tem includes parts such as the carbure-
tor and the ignition system. Where a
warrantable condition exists, Sears will
repair your small off-road engine engine
at no cost to you. Expenses covered un-
der warranty include diagnosis, parts
and labor. MANUFACTURER'S
WAR-
RANTY COVERAGE:
If any emissions
related part on your engine (as listed un-
der Emissions Control Warranty Parts
List) is defective or a defect in the mate-
21
Advertisement
