Storage; Troubleshooting - Craftsman WEEDWACKER 358.745121 Instruction Manual

USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065 inch Trimmer Line
Assist Handle
Bolt Carri&qe, 1/4-20
Wing Nut
Shield Assembly
PARTNUMBER
71-85837
530403805
530403886
530016118
530403916
_JkWARNING: Perform the follow-
ing steps after each use.
• Stop the unit and disconnect the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.
TROUBLESHOOTING TABLE
,_ WARNING: Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE
Trimmer head
stops under a
load or does not
turn when switcl
is pressed.
Line does not
advance or
_aks while
cu_ing.
Line welds onto
spool.
Line _leases
continuously.
Line usage is
_xcessive.
Line pulls back
into head,
CAUSE
1. Crowding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown circuit breaker.
4. Debris stopping head.
1. Line improperly routed
in head.
2. Line improperly
wound into spool.
3. Incorrect line s_ze
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Line size is incorrect.
2. Incorrect spool,
3. Line is being crowded
against material being
cut.
1. Line improperly
routed in head.
2. Spool damaged.
1. Line improperly routed
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged
1. Too little line outside
of head.
2. Line size incorrect.
REMEDY
1. Allow tip of line to do the cutting.
2. Contact Sears Sewice (see back
cove0.
3. Check Breaker Box.
4. Remove debris.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 inch (1.65 mm) dia. line.
4. Remove cover and pull 4 inches
(10 cm) of line out of head.
5. Clean unit.
1. Use only 0.065 inch (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut with tip of line fully extended.
1. Check line routing.
2. Replace spool.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Remove cover and pulI 4 inches
(10 cm) of line outside of head,
2. Use only 0.065 inch (1.65 mm) dia. line.
9