..............
ill ii
i ,Ill
,
lu
i
I i
nl
II
nlunull
L ,it,Jl
I
SERVICE AN
ADJUSTMENTS
n ,i
...................................
i_,ln
I
i,
lUl lU, ...................................
TO REPLACE
FUSE (See Fig. 27)
TO REMOVE
HOOD AND GRILL (See Fig. 28)
fuse holder is located in the engine compartment, directly
CAUTION:
Muffler is hot.
Be careful
in front of the dash
when removing
retainer
springs
from
hood pivot brackets,
,i
i/
•
Raise hood.
O
FUSE
HOLDER
FIG. 27
TO REPLACE
HEADLIGHT
BULB
•
Raise hood,
•
Pull bulb holder out of the hole in the backside of the
grill,
•
Replace butb in holder and push bulb holder securely
back into the hote in the backside of the grili,
•
Close hood,
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting,
•
Check wiring, See the electrical wiring diagram in the
Repair Parts section of this manual.
.
Unsnap headlight wire connector.
•
Remove retainer springs from hood pivot brackets.
o
Stand in front of tractor.
Grasp hood at sides, tilt
forward and lift off of tractor°
•
To reinstall, slide hood pivot brackets into slots in
frame,, Replace retainer spring&
•
Reconnect headlight wire connector and close hood.
HOOD
HEADLIGHT
CONNECTOR
REMOVE
RETAINER
SPRINGS
FIG. 28
22