Craftsman WEEDWACKER 358.796160 Operator's Manual page 4

UNIT / MAINTENANCE SAFETY
_.WARNING: Disconnect the
spark plug before performing mainte-
nance except carburetor adjustments,
• Look for and replace damaged or
loose parts before each use. Look for
and repair fuel leaks before use. Keep
in good working condition,
• Replace trimmer head parts that are
chipped, cracked, broken, or dam-
aged in any other way before using
the unit,
• Maintain unit according to recom-
mended procedures. Keep cutting
line at proper length,
• Use only CraftsmanCR_ brand line.
Never use wire, rope, string, etc.
• Install required shield properly before
using the unit. Use only specified trim-
mer head; make sure it is properly
installed and securely fastened.
• Make sure unit is assembled correctly
as shown in this manual.
• Make carburetor adjustments with
lower end supported to prevent line
from contacting any object.
• Keep others away when making car-
buretor adjustments.
• Use only recommended Craftsman
accessories and replacement parts.
• Have all maintenance and service not
explained in this manual performed
by a Sears Service Center.
FUEL SAFETY
• Pour fuel outdoors.
• Keep away from sparks or flames.
• Use a container approved for fuel.
• Do not smoke or allow smoking near
fuel or the unit.
• Avoid spilling fuel or oil. Wipe up all
fuel spills.
• Move at least 10 feet (3 meters) away
from fueling site before starting en-
gine. Stop engine and allow to cool
before removing fuel cap.
• Empty the fuel tank before storing or
transporting the unit. Use up fuel left in
the carburetor by starting the engine
and letting it run until it stops.
• Store unit and fuel in area where fuel
vapors cannot reach sparks or open
flames from water heaters, electric
motors or switches, furnaces, etc.
• Always store gasoline in a container
approved for flammable liquids.
TRANSPORTING AND STORAGE
• Stop the unit before carrying.
• Allow engine to cool before storing or
transporting in vehicle.
• Empty the fuel tank before storing or
transporting the unit. Use up fuel left in
the carburetor by starting the engine
and letting it run until it stops.
• Store or transport unit with spark plug
facing up.
• Do not store or transport unit with
spark plug facing down (see STOR-
AGE section for additional informa-
tion).
• Store unit and fuel in area where fuel
vapors cannot reach sparks or open
flames from water heaters, electric mo-
tors or switches, furnaces, etc.
• Store unit so line limiter blade cannot
accidentally cause injury.
• Store unit out of reach of children.
This unit is not equipped with an anti-
vibration system and is intended for
occasional use only.
SAFETY NOTICE: Exposure to vibra-
tions through prolonged use of gasoline
powered hand tools could cause blood
vessel or nerve damage in the fingers,
hands, and joints of people prone to cir-
culation disorders or abnormal swell-
ings. Prolonged use in cold weather
has been linked to blood vessel dam-
age in otherwise healthy people. If
symptoms occur such as numbness,
pain, loss of strength, change in skin
color or texture, or loss of feeling in the
fingers, hands, or joints, discontinue the
use of this tool and seek medical atten-
tion. An anti-vibration system does not
guarantee the avoidance of these prob-
lems. Users who operate power tools
on a continual and regular basis must
monitor closely their physical condition
and the condition of this tool.
SPECIAL NOTICE: This unit is
equipped with a temperature limiting
muffler and spark arresting screen
which meets the requirements of Cali-
fornia Codes 4442 and 4443. All U.S.
forest land and the states of California,
Idaho, Maine, Minnesota, New Jersey,
Oregon, and Washington require by
law that many internal combustion en-
gines be equipped with a spark arrest-
ing screen. If you operate in a locale
where such regulations exist, you are
legally responsible for maintaining the
operating condition of these parts.
Failure to do so is a violation of the
law. For normal homeowner use, the
muffler and spark arresting screen will
not require any service. After 50 hours
of use, we recommend that your muf-
fler be serviced or replaced by a
Sears Service Center.