Advertisement
OPERATING
INSTRUCTIONS
To maximize
operating
efficiency,
do
not run the engine for longer than 30
seconds
at a time at full throttle.
Releasing
the trigger and allowing the
engine to briefly return to idle speed
(5-10 seconds)
will be sufficient.
IMPORTANT
POINTS
• Use the minimum
throttle speed nec-
essary to effectively
cut hedges for
optimal hedge trimmer performance.
• Never attempt to use this hedge trim-
mer to cut hedges that have any
branches
with a diameter larger than
3/4".
OPERATING
POSITION
Hearing
Protection
Protection
1. Move the ON/OFF switch to the ON
position.
2. Engage the throttle lock as follows:
• press the throttle lock-out;
• squeeze
and hold throttle trigger;
• press and hold throttle lock;
• release the throttle trigger
NOTE:
Keep the throttle lock engaged
until the engine starts.
ON
OFF
3. Slowly
press
the primer
bulb
6 times.
4. Move
the choke
lever
to the FULL
CHOKE
position.
Primer
Bulb
Choke
Lever
STOPPING
YOUR ENGINE
• To stop the engine, move the ON/OFF
switch to the OFF position.
BEFORE STARTING
THE ENGINE
• Fuel engine. Move at least 10 feet (3
meters) away from the fueling
site.
• Hold the unit on the ground in the
starting position as shown. Support
unit so the blade is off of the ground
and away from trees, bushes,
on-
lookers,
etc.
TL-.:/',,
,I_S /
STARTING
A COLD ENGINE (or a
warm engine after running
out of
fuel)
Throttle Lock
X
Throttle
Lock-out
/
,
Throttle
Trigger
1
/
6,
7.
Pull starter rope handle sharply
until
engine sounds as if it is trying to run,
but do not pull rope more than 6
times.
Move the choke lever to the HALF
CHOKE position.
Pull starter rope sharply until the en-
gine runs, but no more than 6 pulls.
NOTE:
If the engine doesn't start af-
ter 6 pulls (at the HALF CHOKE posi-
tion), check to make sure the ON/
OFF switch is in the ON position.
Move the choke lever to the FULL
CHOKE position and press the prim-
er bulb 6 times; pull the starter rope
2 more times. Move the choke lever
to the HALF CHOKE position and pull
the starter rope until the engine
runs, but no more than 6 more pulls.
If the engine still doesn't start, it is
probably flooded.
Proceed to
STARTING A FLOODED ENGINE.
Once the engine starts, allow it to
run 10 seconds,
then move the
Advertisement
