Assembly; Tools Required For Assembly; Operator's Position; Contents Of Hardware Pack - Craftsman 917.299881 Owner's Manual

iiiiiiiiiillllllllll illlll ii
ASSEMBLY
Your new tiller has been assembled at thefactory with exception of those parts left unassembled for shipping purposes. To
ensure safe and proper' operation of your tiller all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness°
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(t) Screwdriver
(t) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiIler handles)_
FRONT
LEFT RIGHT
OPERATOR'S
POSITION
FIG. 1
CONTENTS OF HARDWARE PACK
, , ,, , ii ,, i ,,lll,,,,ml Ill Illll Illll I Illllllll
(1) Handle Lock
(Black)
(1) Handle Lock
(Silver)
(2) Carriage Bolts
3/8-16 UNC x I Gr. 5
Q
(2) Center Locknuts
3/8-16 UNC
(1) Flat Washer 13/32 x I x 11 Ga.,
©
(1) Handle Lock Lever
(1) Hairpin Clip
(1)Cable Clip
(1) Owner's Manual
6