Thermal Cut-Off - Eureka 8800 Series Owner's Manual

PNS0238A english:OG english 12/16/08 4:08 PH
'\bs
rye,
_<KJ
Thermal Cut-Off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum
suddenly shuts off, push the power switch to off (O) and un@ug the vacuum. Check the vacuum for a possible source of
overheating such as a ful dust cup, blocked hose or clogged filer. If these conditions are found, fix them and wait at least
30 minutes before attempting to use the vacuum. After the 30 minute period, @ug the vacuum back in and turn on the
switch. If the vacuum stil does not work, take it to a Eureka authorized service center for repair or cal 1-800-282-2886.
Problem
Vacuum does not
clean carpet or bare
floor.
Problem Solving
,_ Make sure vacuum is turned off and power cord is unplugged.
Dust cup and filters
Solution
Empty dust cup, clean and/or change filters.
If picking up fine dust, the dust cup may not look full, but
a fine substance tends to reduce suction when it blocks
air flow through the foam filter and filter screen. Refer to
page 2 for filter maintenance. Make sure foam filter, filter
screen and dust cup are installed properly.
Belt • Replace a worn, cut or out of shape belt. Page 4
Hose • Remove any clogs from the hose that restrict the
airflow. Page 5
Bare floor setting • For bare floor cleaning, turn height adjustment knob to
bare floor position.
Carpet height setting • For carpet cleaning, turn height adjustment knob to
another position.
Vacuum is hard Vacuum height setting • Adjust knob to a higher position.
to push.
Belt ,, Re@ace a worn, cut or out of shape belt. Page 4
rP,
'\KJ
6 Eureka Customer Service HELPLINE 1=800=282=2886 www.eureka.com
i
<T%