Advertisement
1. LOuDSPEAKER OuTPuTS – RIGHT and LEFT:
Connect to right and left speakers according-
ly. Use only speakers supplied with MATRIX-
200 System.
2. SuBWOOFER OuTPuT: XLR output to connect
optional active subwoofer to the MATRIX-200.
While the MATRIX-200 is a full range active
system, the very low frequency performance
can be enhanced by adding an external sub-
woofer. The subwoofer will both extend the
range of the system, and add increased low
frequency output ability. The subwoofer XLR
output jack has both left and right channels
combined, minus the
higher frequencies sent to, and reproduced by
the satellite speakers. The XLR output only has
signal present when the "sub sw" (sub switch;
item # 3) is in the on position.
3. SuBWOOFER ON/OFF: Used to activate
subwoofer output (2), and to activate high
pass filters on main channels. This improves
performance of the system by causing a more
ideal acoustical summation of the subwoofer
and main speakers. It does so by limiting
cone excursion, and by increasing the head-
room available to both the speakers and
amplifier.
4. HEADPHONES: 1/4" stereo jack used to
connect headphones for monitoring when
speaker use is not possible, or if headphones
are preferable. NOTE: This jack is inactive
if the speaker cables are inserted into the
speaker output jacks (1).
5. VOLTAGE SELECTOR SWITCH: DO NOT
CHANGE THIS SETTING WITH THE AC MAINS
POWER ATTACHED! This switch is only used to
modify the unit when it is transported to a dif-
ferent location with a different available AC
mains source (such as moving a unit bought
in the USA to Europe). Please check that this
switch is in the appropriate position for your
local electric source.
WARNING: Using an improper setting on this
switch can destroy the MATRIX-200, create
an electrical hazard and void your warranty!
Do not change this setting unless you must to
match to the AC mains power available.
6. POWER ON/OFF: Press this switch to turn
the MATRIX-200 on or off .
7. AC INLET: Male IEC AC mains connector
for standard detachable AC mains cords.
This cord will also need to change if the unit
is moved between regions with different AC
mains voltages. It will require an AC mains
switch setting change as well.
8. FuSE HOLDER: This fuse depends on your
local AC Mains voltage. For 115V setting,
this fuse is a 5amp T5AL. For the 230V set-
ting, the fuse used is a T2.5AL as shown.
CAuTION: Connect the power cable only after you have absolutely made sure that the local mains
voltage matches the voltage specified on the device. If you connect to the wrong voltage, you may
destroy the electronic components of the MATRIX-200 system.
6
MatRiX-200 REaR PanEL
Advertisement
