To Replace Headlight Bulb; Interlocks And Relays; To Replace Fuse; To Adjust Throttle Control Cable - Craftsman 917.252451 Owner's Manual

SERVmCE ADJUSTMENTS
ENGBNE TO REPLACE HEADLIGHT BULB
= Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
o Close hoo&
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
= Check wiring. See electrical wiring diagram in Repair
Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash,
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 28)
• Raise hoe&
o Unsnap headlight wire connector.
o Stand in front of tractoro Grasp hood at sides, tilt toward
engine and lift off of tractor.
° To replace, reverse above procedure.
HOOD
HEADLIGHT
WIRE
CONNECTOR
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 29)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
o With engine not running, move throttle control lever
from slow (=_) to choke ( \ ) position. Slowly move
lever from choke ( \ ) to fast (,_) position
o Check that holes"A" in governor control lever and hole
in governor plate line-up. If holes "A" are not aligned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely,
GOVERNOR
CONTROLLEVER
GOVERNOR
CONTROLPLATE
\
HOLES"A" CLAMP THROTTLE
SCREW CABLE
FIG. 29
FIG. 28
23