Craftsman 919.161020 Manual page 6

Operatinq The Paint Tank (cont')
PRESSURE REGULATOR
(DO NOT EXCEED 80 PSI)
AIR
AIR REGULATOR (RECOMMENDED,
/ NOT INCLUDED)
AIR COMPRESSOR
WITH REGULATOR
AIR FILTER
(RECOMMENDED,
NOT INCLUDED)
MATERIAL HOSE
(INSIDE PAINT TANK)
J
Cleaninq Instructions
Always shut off air pressure at source and
bleed off all pressure in Paint Tank by
gently pulling safety valve ring before
loosening thumb screw and clamps to re-
move lid.
It is very important that the tank, material hose, and spray
gun be cleaned as soon as spray job is finished. Turn off
the main air supply to the tank. Remove all pressure from
the tank by pulling the ring on the safety valve until the
pressure bleeds down. Turn the T-handle adjusting screw
on the regulator counter-clockwise until no spring tension
is felt.
Loosen thumb screws, tip clamps back and tip tank lid to
one side. Loosen spray gun air cap retaining ring about
three turns then turn on the air supply. Cup cloth over air
cap on the gun and pull trigger. This will force the material
back through the hose, into the tank. Empty and clean
tank and parts which come in contact with the material.
Use a suitable solvent. Pour solvent into the tank.
Replace lid and tighten the thumb screws and clamps
and spray until clean solvent appears.
6- ENG